LayoutElementBuilders.Arc.Builder

fun addContent(content: LayoutElementBuilders.ArcLayoutElement): LayoutElementBuilders.Arc.Builder

Adds one item to contents of this container.

fun build(): LayoutElementBuilders.Arc

Builds an instance with values accumulated in this Builder.

fun setAnchorAngle(anchorAngle: DimensionBuilders.DegreesProp): LayoutElementBuilders.Arc.Builder

Sets the angle for the anchor, used with anchor_type to determine where to draw children. Note that 0 degrees is the 12 o clock position on a device, and the angle sweeps clockwise. If not defined, defaults to 0 degrees.

Values do not have to be clamped to the range 0-360; values less than 0 degrees will sweep anti-clockwise (i.e. -90 degrees is equivalent to 270 degrees), and values >360 will be be placed at X mod 360 degrees.

fun setAnchorType(anchorType: Int): LayoutElementBuilders.Arc.Builder

Sets how to align the contents of this container relative to anchor_angle. If not defined, defaults to ARC_ANCHOR_CENTER.

fun setAnchorType(anchorType: LayoutElementBuilders.ArcAnchorTypeProp): LayoutElementBuilders.Arc.Builder

Sets how to align the contents of this container relative to anchor_angle. If not defined, defaults to ARC_ANCHOR_CENTER.

fun setModifiers(modifiers: ModifiersBuilders.Modifiers): LayoutElementBuilders.Arc.Builder

Sets androidx.wear.tiles.ModifiersBuilders.Modifiers for this element.

fun setVerticalAlign(verticalAlign: Int): LayoutElementBuilders.Arc.Builder

Sets vertical alignment of elements within the arc. If the Arc's thickness is larger than the thickness of the element being drawn, this controls whether the element should be drawn towards the inner or outer edge of the arc, or drawn in the center. If not defined, defaults to VERTICAL_ALIGN_CENTER.

fun setVerticalAlign(
    verticalAlign: LayoutElementBuilders.VerticalAlignmentProp
): LayoutElementBuilders.Arc.Builder

Sets vertical alignment of elements within the arc. If the Arc's thickness is larger than the thickness of the element being drawn, this controls whether the element should be drawn towards the inner or outer edge of the arc, or drawn in the center. If not defined, defaults to VERTICAL_ALIGN_CENTER.